Replacing A Cfp Transceiver Module - H3C CR16000-F Installation Manual

For more information, see "Attaching an ESD wrist strap."
2. Remove the optical fibers from the module.
There is a latching mechanism between a fiber connector and transceiver module bore to
prevent connector disengagement. Release the latching mechanism before removing the
optical fiber. To avoid damages, do not use excessive force.
3. Pivot the bail latch down to the horizontal position.
4. Hold the bail latch to pull the module out of the slot. Make sure you apply force in the direction
parallel to the ground. To avoid damaging the bail latch, do not use excessive force.
If you apply force at an angle when pulling the module out, you can hardly pull the module out
and the module or fiber port might be damaged.
5. Insert dust plugs into the removed module, and put the module into its packaging bag.
6. Install a new module. For the installation procedure, see "Installing an
XFP/QSFP+/QSFP28/SFP28/SFP+/SFP module."
Figure 11 Removing an SFP+ transceiver module
1

Replacing a CFP transceiver module

1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "Attaching an ESD wrist strap."
2. Remove the optical fibers from the module.
There is a latching mechanism between a fiber connector and transceiver module bore to
prevent connector disengagement. Release the latching mechanism before removing the
optical fiber. To avoid damages, do not use excessive force.
3. Loosen the captive screws on the module.
4. Carefully pull the module out of the slot. Make sure you apply force in the direction parallel to
the ground.
If you apply force at an angle, you can hardly pull the module out and the module or fiber port
might be damaged.
5. Insert the plugs into the removed module, and put the module into its packaging bag.
6. Install a new module. For the installation procedure, see "Installing a CFP module."
2
10