Oaa Module Leds - H3C CR16000-F Installation Manual

Table 40 BMC network port status LED description
Status
Steady green
Flashing green (1 Hz)
Off
Table 41 Hard disk LED description
Fault/UID LED status
Flashing amber (0.5 Hz)
Steady amber
Steady blue
Off
Off
Off

OAA module LEDs

The OAA module provides LEDs to show the operating status of the module and ports.
Table 42 LED description
Status
ALM
Off
Steady red
RUN
Off
Steady green
Flashing green (1 Hz)
Fast flashing green (8 Hz)
LINK/ACT (for the combo interface)
Off
Steady green
Flashing green
Description
The network port is being activated.
The network port is receiving or sending data.
The network port is not connected.
Present/Active status
Steady green /Flashing green
(4 Hz)
Steady green /Flashing green
(4 Hz)
Steady green /Flashing green
(4 Hz)
Flashing green (4 Hz)
Steady green
Off
Description
The system is operating correctly.
A serious failure has occurred.
You must read the system log for troubleshooting immediately.
No power is being input or the card is faulty.
The system is not operating correctly.
The system has started up and is operating correctly.
The system is loading software or is not operating.
No link is present on the port.
A link is present on the port.
The port is receiving or sending data.
14
Description
A hard disk failure is predicted. As a best
practice, replace the hard disk before it fails.
The hard disk is faulty. Replace the hard disk
immediately.
The hard disk is operating correctly and is
selected by the RAID controller.
The hard disk is performing a RAID migration
or rebuilding, or the system is reading or
writing data to the hard disk.
The hard disk is present but no data is being
read or written to the hard disk.
The hard disk is not securely installed.