Replacing An External Cf Card - H3C MSR 56-60 Replacement Procedures

To install new slide rails, see "Installing the router."
Figure 16 Removing slide rails

Replacing an external CF card

CAUTION:
Before you remove an external CF card on an operating router, execute the umount cfb0:
command.
To replace a CF card:
1. Execute the umount cfb0: command in user view to unmount the file system and wait until the
system displays a message that the file system has been unmounted.
Skip this step if the router is powered off.
2. Press down the spring clip of the CF card cover and open the cover.
3. Press the CF card eject button of the CF card reader so that the eject button projects from the
panel.
4. Press the eject button again to eject the CF card part-way out of the CF card reader, and then
pull the CF card out of the CF card reader.
Keep the removed CF card for future use.
5. Install a new CF card. For the installation procedure, see "Installing the router."
If you do not install a new CF card, close the CF card cover.
10