H3C CR16000-F Installation Manual page 205

Figure 7 Using the L-type brackets to secure the chassis to the wooden pallet base
(CR16006-F)
(1) L-type bracket
5. Cover the chassis with the packing bag from the top down, and then tape the bag to the plastic
cover of pallet base.
6. Cover the foam cushion to the chassis top, and make sure the mounting brackets seat into the
internal notches of the foam cushion.
7. Put the accessories box in the notch in the top middle of the foam cushion.
8. Use a cardboard box or a wooden box to package the chassis.
For the CR16018-F router and CR16018-FA router, attach the four wooden side panels of

the wooden box to the pallet base.
For the CR16006-F, CR16010-F, CR16010H-FA, and CR16010H-F routers, erect one paper

angle bead along each vertical edge of the chassis, and use the cardboard box to cover the
chassis from top down with the silkscreen side facing the front panel of the chassis.
9. Cover the top cap of the cardboard box or wooden box. Skip this step for the CR16006-F router.
For the CR16018-F router and CR16018-FA router, cover the top cap to the wooden box,

and then connect the panels with corro clips on each seam.
For the CR16010-F, CR16010H-FA, and CR16010H-F routers, cover the top cap to the

cardboard box.
(2) Bolt
7