Powering On The Router - H3C CR16000-F Installation Manual

Powering on the router

IMPORTANT:
The CR16010H-F, CR16010H-FA,CR16018-FA, and CR16018-F routers each have two power
switches. To power on the router, turn on both power switches.
Before powering on the router, verify the following items:
•
You know where the emergency power-off router for the equipment room is located.
•
The router has been securely mounted.
•
All the cards have been correctly installed.
•
The unused slots have been installed with filler panels.
•
All the network cables, fibers, power cords, and grounding cables have been correctly
connected.
•
The input power voltage meets the requirement of the router.
•
The console cable is correctly connected.
•
The terminal or PC used for configuration has started, and the configuration parameters have
been set.
To power on the router:
1. Turn on the power source of the router.
The following is a sample output you can see on the terminal (console port login):
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Press Ctrl+T to start memory test
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing.........Done.
...
BootWare Validating...
Press Ctrl+B to access EXTENDED-BOOTWARE MENU...
2. Enter 1.
The system image file is loaded.
Enter your choice(0-9): 1
Loading the main image files...
Loading file flash:/temp-system.bin...........................
............................................................................
............................................................................
.............................Done.
Loading file flash:/temp-boot.bin.............................
......Done.
Image file flash:/temp-boot.bin is self-decompressing.........
................................................................Done.
System image is starting...
Finished running batch file.
4