Repackaging The Card; Repackaging The Router Chassis; Removing The Chassis From The Rack - H3C CR16000-F Installation Manual

Repackaging the card

1. Prepare the anti-static bag and box of the card. Make sure the bag is clean, dry, and not
damaged.
2. Remove the transceiver modules from the card. If no transceiver module is installed on the card,
go to the next step.
For information about how to remove a transceiver module, see "Replacing a transceiver
module."
3. Remove all cards from the chassis slots, and install filler panels to the empty slots.
For information about how to remove a card and install a filler panel, see "Replacing a card"
4. Put the card into the anti-static bag.
The switching fabric modules for the routers (except the CR16006-F router) each are provided
with a protection box. Put the switching fabric module into the protection box, and then put the
box into the anti-static bag.
5. Put the packed card into the box, and tape the flaps of the box with packing tape. Place the card
in a correct direction onto the foam cushion in the box; otherwise, the power supply cannot be
completely seated into the foam cushion.

Repackaging the router chassis

Removing the chassis from the rack

The router is heavy. If possible, use a mechanical lift to move the router.
To remove the chassis from the rack:
1. Prepare the wooden box and packing bag of the chassis. Make sure the box and bag are clean,
dry, and not damaged.
2. Remove the top cap and side panels from the wooden box, and put the pallet base to a proper
place.
3. Use a Phillips screwdriver to loosen the screws that attach the mounting brackets to the rack.
4. Use a minimum of two people to slide the chassis outwards along the slide rails. When most
part of the chassis is removed from the slide rails, lift up the chassis by holding the handles at
the chassis sides to completely remove the chassis from the rack.
5. Put the chassis onto the pallet base of the wooden box.
Figure 2 Removing the chassis from the rack
1
1
3
2