Figure 6 CR16010H-F chassis depth
1
1
(1) Handle at the rear of the chassis
NOTE:
• If the rack does not meet the requirements described in
closed after you install the router of standard configurations in the rack.
• The signal cables and power cords are routed through the front of the chassis. If you use power
cords that has a conductor cross-section area of a minimum of 16 sq mm (0.02 sq in), leave more
space between the front rack posts and the front door as appropriate.
Tools and equipment
No installation tools and equipment are provided with the router. Prepare installation tools and
equipment yourself as required.
installation.
663 mm
(26.10 in)
(2) Cable management bracket
Table 6
lists the tools and equipment that you might use during
10
114 mm
(4.49 in)
Table
5, the rack door might fail to be
2