H3C CR16000-F Installation Manual page 155

Table 35 System power status LED description
LED
Power on/standby button
and system power LED
Table 36 Health LED description
Status
Steady green
Flashing green (4 Hz)
Flashing green and
yellow (1 Hz)
Flashing yellow (1 Hz)
Table 37 Run LED description
Status
Steady on
Off
Normal flashing (1 Hz)
Fast flashing
Table 38 UID LED description
Status
Steady blue
Flashing blue
Off
Table 39 Shared network port status LED description
Status
Steady green
Flashing green (1 Hz)
Off
Status
Steady green
Flashing green (1 Hz)
Steady amber
Off
Description
The system is operating correctly.
BMC is initializing.
A general alarm has occurred on the system, including BMC monitoring alarm
and hardware alarm.
A severe alarm has occurred on the system, including BMC monitoring alarm,
hardware alarm, and CPU hardware abnormality alarm.
Description
The card is faulty.
The card is faulty or not present.
The card is operating correctly.
The card is starting up. If the LED keeps fast flashing, card registration has
failed.
Description
The UID LED is activated.
The UID LED can be activated by using any of the following methods:
Press the UID button.
Turn on the UID LED via BMC.
•
1 Hz—The system is being remotely managed or the firmware is being
upgraded.
•
4 Hz—BMC is rebooting. To reboot BMC, press the UID button/LED for 8
seconds.
The UID LED is not activated.
Description
The network port is being activated.
The network port is receiving or sending data.
The network port is not connected.
13
Description
The system has started up.
The system is starting up.
The system is in standby mode.
No power input.