Matrox Extio 3 Series User Manual page 72

2 Click
monitors.
On the touch screen of the monitor (
3
the designated area in the middle of the OSD where
appears. Note: The firmware detects your touch on the screen and links the
corresponding digitizer USB device and its port number to the current monitor being
calibrated.
4 Repeat step 3 for all the touch-screen monitors.
For a monitor without touch screen, click the
5
bottom of the screen to skip. Repeat for each non touch-screen monitor that is detected.
When you're done, click
6
corresponding digitizer USB devices.
If the digitizer USB device doesn't have a serial number, the digitizer matching information is lost
when the digitizer USB device is changed to a different USB port. In this case, you have to do the
matching procedure again.
Note:
monitor identification
72 Matrox Extio 3 Series – User Guide
. The
Yes Touch screen monitor identification
OK
The matching procedure can also be done at any time by using the
button in the
) identified on the top-left corner of the screen, tap
x
Not a touch screen monitor
. The touch-screen monitors are now matched with their
section under
Monitors
screen on the OSD appears on all the
Touch the screen of monitor x
Touch screen
tab 
Receiver Settings
button at the
.