Matrox Extio 3 Series User Manual page 14

some settings related to this operation mode (such as
and
Central Manager software.
5 Install your Extio Central Manager software –
Manager software", page
Configure your Extio devices through the Extio Central Manager software (Network
6
Administrator). Note: You must discover the receivers manually (
discovery
settings. For more information on using the Extio Central Manager software, see the
Matrox Extio Central Manager User Guide.
14 Matrox Extio 3 Series – User Guide
). If not, you need to apply the settings for this mode from the Extio
Encoding quality
62.
), then discover the transmitters using
 Manually discover the receivers (
).
addresses
 If the receivers and transmitters are on different subnets, make sure to configure the
receiver units to scan the transmitter subnets (
). If not, in the device tile, you will see a settings icon with a popup message
discovery
"Transmitter discovery settings are not set. Receiver will not be able to see any
transmitter."
Assign user(s) to the devices using

 Allow the receiver and transmitter units to connect to one another using
.
broker
 Set a value for
Sharing mode

mode Guest connections
Press the button beside the

Change
 
Settings Network
settings for a private WAN configuration.
Set the Maximum Transmission Unit (

is set automatically to 1400 when you apply the
or when you select
Reset configuration
Networked-Enable Internet / WAN with Site-to-Site VPN
screen.
operation mode
Set the

Encoding quality
is set automatically to
or when you select
Reset configuration
Networked-Enable Internet / WAN with Site-to-Site VPN
screen.
operation mode
 Set a value for
Network congestion control
The values are ,
Off Low
see "Installing Matrox Extio Central
Transmitter discovery
Manual device discovery
Manage users
( 
Transmitter
).
Currently Adapted for LAN
) to automatically update certain
Adapt for WAN / LAN
) to the recommended
MTU
in the Firmware updater and choose the
to (
Low Transmitter
when you apply the
Low
in the Firmware updater and choose the
(
Transmitter
, , and .
Mid High
Currently adapted for WAN
Manual device
from the receiver

Scan a list of IP
 
Receiver Settings
.

Settings Connection
field (
1400
Currently Adapted for WAN
option in the
 
Settings Streaming
Currently Adapted for WAN
option in the

Settings
, ,
MTU
Transmitter
Connection

Sharing

Receiver
. : This
Note
settings,
Select the
). : This
Note
settings,
Select the
 ).
Streaming