Validating Network Discovery; Installing Matrox Extio Central Manager Software - Matrox Extio 3 Series User Manual

 To assign an initial IP address to your devices, a DHCP (Dynamic Host Configuration
Protocol) server is required.
 Windows Server 2022 and 2019 – Make sure the SSDP Discovery service, network
discovery, and file sharing options are enabled.
 Review the safety information provided. For more information,
information", page
Software available in networked mode
 Extio Central Manager
 On-Screen Display (OSD)

Validating network discovery

Extio 3 devices are initially assigned their IP addresses through DHCP (Dynamic Host Control
Protocol). After connecting your devices, we recommend verifying that all of your devices are
discovered by the network.
Windows 11/10/7 – To make sure all of your devices are discovered by the network:
Windows 11 and Windows 10 – Click

Devices
 Windows 7 – Click
Devices
If prompted to enable network discovery and file sharing on your network when validating network
discovery, enable these two features by clicking on the prompt at the top of your Windows Explorer
window. These two features must be enabled for Extio Central Manager software to detect the Extio 3
devices.

Installing Matrox Extio Central Manager software

Matrox Extio Central Manager software enables you to remotely manage, monitor,
and configure your networked Extio 3 devices.
Supported operating systems
Matrox Extio Central Manager supports the following operating systems: Windows® Server® 2022,
Windows® Server® 2019, Windows® 11 (64-bit), Windows® 10 (64-bit), and Windows® 7 (64-bit).
62 Matrox Extio 3 Series – User Guide
6.
, make sure all the Extio 3 devices connected are listed.

Start Accessories
, make sure all the Extio 3 devices connected are listed.
 
Start File Explorer

Windows Explorer
see "Matrox safety
. Under
Network Other
 . Under
Network Other