Matrox Extio 3 Series User Manual page 69

 USB switching – By default, you can use your mouse to switch between sources. You can
also use a keyboard shortcut to switch sources. To use only keyboard shortcuts (no
mouse) to switch sources, in Extio Central Manager, select a Receiver, then go to the
Keyboard shortcuts
USB switching
 Dynamic sources – You can dynamically change the transmitter source (stream from a
system) displayed on one of the monitors attached to a receiver in aggregator mode. This
enables you to easily access and switch between different systems from a large group
(pool) of systems to view the stream currently of interest to you, without affecting the
other displays.
 Tile display - A tile display configuration is one where streams are displayed in multiple
tiles in a 4K monitor. A 4Kp60 resolution tiled display appears on Output 4 only. You can
see two 4Kp30 resolution tiled displays in a layout - on Outputs 1 and 4. Note: You can't
have dynamic sources in a tile display.
Operating system - Certain limitations may occur. For more information on operating

system compatibility with aggregator mode, see the Matrox Extio 3 Series Release Notes.
Switching between dynamic sources
You can change the dynamic source as frequently as you like.
To switch to a different source:
1 Open the on-screen-display (OSD) and click the
keyboard shortcut to go directly to the
source streams from the accessible transmitter units. Each source is shown with its
preview image, the friendly name of the transmitter, and the source input number. If a
transmitter has only a single available source, the input number is omitted.
page, and enable the
option.
 Dynamic sources is shown on only one monitor in aggregator mode. All the other
monitors will display fixed sources.
Dynamic sources feature is supported only while using aggregator mode.

Use only keyboard shortcuts (no mouse) for
Dynamic sources
tab). This tab contains all the
Dynamic sources
Matrox Extio 3 Series – User Guide 69
tab (or, you can use the