Matrox Extio 3 Series User Manual page 13

6 Install your Extio Central Manager software –
Manager software", page
Configure your Extio devices through Extio Central Manager software – For more
7
information on using Extio Central Manager software, see the Matrox Extio Central
Manager User Guide.
Log into your receiver and switch to different transmitters (OSD) –
8
(On-Screen Display)", page
Networked-Internet / WAN with Site-to-Site VPN mode
In Networked-Internet / WAN with Site-to-Site VPN mode, the Extio 3 devices operate over the
internet or a wide-area-network (WAN) where there is a site-to-site virtual private network (VPN)
connection.
The following are the prerequisites to setting up Extio 3 IP KVM extenders to operate over Internet /
WAN with Site-to-Site VPN:
 Firmware version - Extio 3 firmware version 3.01.50 or 3.03.00 or higher (version 3.02
does not support this feature).
 Bandwidth - You need to ensure that the required network bandwidth is available for
your setup. Bandwidth requirement is tied to the video resolution, number of video
streams, and the application running on the source system. For more information,
"Typical bandwidth requirements", page
 VPN tunnel - A VPN tunnel needs to be established between the transmitter and
receiver.
 Low network latency - Latency is the measure of time it takes for a data packet to travel
from one point to another. When configuring your WAN network, it would be best to
have as low a latency as possible.
Do the following to operate your Extio 3 units over the internet or WAN with Site-to-Site VPN:
Connect your devices –
1
Validate your setup –
2
Make sure the transmitter and receiver units are on the same VPN.
3
Update your firmware to v3.01.50 or 3.03.00 or higher using the
4
UpdaterOverNetwork.exe
All of your units need to be running the same version of the firmware. Note: If you
selected
when updating your firmware, you can select the
Site-to-Site VPN
62.
64.
see "Connecting your Extio 3 devices", page
see "Description of LEDs", page
tool –
in the
Reset configuration
option in the
Select the operation mode
see "Installing Matrox Extio Central
15.
43.
see "Updating your Extio 3 firmware", page
Matrox Extio 3 Series Updater over Network
Networked-Enable Internet / WAN with
Matrox Extio 3 Series – User Guide 13
see "Using the OSD
31.
47. Note:
screen
screen to automatically apply
see