Link Redundancy; Changing The Osd Keyboard Settings - Matrox Extio 3 Series User Manual

2 Connect your devices –
Validate your setup –
3
4 The network administrator must create and configure the Strongswan.zip files so that the
remote receiver units will be able to communicate with the transmitter units. Once these
files have been created, they need to be provided to the remote user.
5 The remote user must then import the VPN configuration (Strongswan.zip) from a USB
mass storage device from the OSD and apply to the receiver device. For more
information,
Connect to the VPN from the OSD. When you are in VPN mode, the interface is similar
6
to when you are connected in networked mode, except for the additional
You will not be able to log in unless you connect to the VPN successfully.
Update your firmware using the
7
Extio 3 firmware", page
3.03 or higher of the firmware.
Install your Extio Central Manager software –
8
Manager software", page
Configure your Extio devices through the Extio Central Manager software. Note: You
9
must discover the receivers manually (
transmitters using
information on using the Extio Central Manager software, see the Matrox Extio Central
Manager User Guide.
10 Log into your receiver and switch to different transmitters (OSD) –
(On-Screen Display)", page

Link redundancy

Link redundancy is a vital safety feature in Point-to-Point and Networked-LAN modes of operation
that Extio 3 supports. For more information on connecting a redundant network,
redundancy", page

Changing the OSD keyboard settings

You can change the keyboard settings in the OSD user interface.
16 Matrox Extio 3 Series – User Guide
see "Connecting your Extio 3 devices", page
see "Description of LEDs", page
see "VPN configuration", page
47. Note: All of your units need to be running version 3.01.50 or
75.
Transmitter discovery
76.
41.
43.
20.
UpdaterOverNetwork.exe
see "Installing Matrox Extio Central
Manual device discovery
from the receiver settings. For more
31.
tab. Note:
VPN
tool – see "Updating your
), then discover the
see "Using the OSD
see "Setting up link