Table of Contents
Advertisement
Configure the units (network administrator)
The network administrator has to detect and configure all the devices from the Extio Central Manager
(ECM) software.
Since the UPnP automatic discovery will not work in VPN mode, the network
1
administrator has to perform a manual scan from ECM
receiver units, to take ownership of them and assign users.
When the units have been detected, the administrator can configure all their connections
2
and user settings. For all the receiver units, the administrator must go to
discovery
unit(s) to which the user has access.
Once the network administrator completes the configuration in the ECM, the regular network OSD
Login screen will appear for the user. When the user logs into the unit, they will have access to their
assigned transmitter units just like in a regular network configuration.
Note: An Active Directory user should have access to the domain resolver and thus to be
connected to the company through the VPN.
Set the required receiver and transmitter settings
The following settings need to be done on the receiver and transmitter units.
On the receiver:
Fast switch should be enabled (in Extio Central Manager
corresponding row/column of the transmitter/receiver
24 Matrox Extio 3 Series – User Guide
and enter either the IP address or a range of IP addresses for the transmitter
to find the
Device discovery
Transmitter
Connection broker
).
Advertisement
Table of Contents
