Using The Osd (On-Screen Display) - Matrox Extio 3 Series User Manual

Change the keyboard shortcut through Extio Central Manager. For more information, see your
Matrox Extio Central Manager User Guide.
Enabling Networked-LAN or Networked-Internet / WAN with Site-to-Site
VPN mode
Note:
from Point-to-Point mode to Networked-LAN or Networked-Internet / WAN with Site-to-
Site VPN mode), you need to perform a configuration reset of your devices. For more
information,
To use your devices in Networked-LAN or Networked-Internet / WAN with Site-to-Site VPN mode,
click the
Enable LAN
screen, in the
Networked
For more information,
and password. To obtain a user name and device password (or if you've forgotten your user name or
device password), contact your Extio 3 administrator.

Using the OSD (On-Screen Display)

If your devices are networked, the OSD enables you to log into your receiver and switch to different
transmitters.
Basic functions
Logout
Search
Wake-on-LAN
Rescan network
Disconnect
Connect
Close
64 Matrox Extio 3 Series – User Guide
To change the operation mode of your Extio 3 configuration (for example, changing
see "Changing the operation mode of your devices", page
or
Enable Internet / WAN with Site-to-Site VPN
section under
Select your operation mode
see "Basic functions", page
Click this to log out of the device.
Search for a system by device serial number, friendly name,
IP address, or name of the user connected.
Click this to wake up your transmitter if it turns off. This has
no effect if a transmitter isn't detected.
Click this to discover devices outside of the receiver's subnet
or unicast network.
Click this to disconnect from a transmitter.
Click this to connect to a new transmitter.
Click this to close the OSD.
button from the OSD startup
. Wait for the mode to be enabled.
64. To use Networked mode, you need a user name
85.