Matrox Extio 3 Series User Manual page 15

Log into your receiver and switch to different transmitters (OSD) –
7
(On-Screen Display)", page
Typical bandwidth requirements
The bandwidth required is typically as specified in the following table:
Resolution per stream
1920 x 1080 @ 60 Hz
1920 x 1200 @ 60 Hz
3840 x 2160 @ 30 Hz
3840 x 2160 @ 60 Hz
* Note: This is for a single video stream including audio and USB HID.
Networked-Internet with IPSec VPN mode
Note:
transmitter will just react to the VPN connection request but will not activate VPN mode
like the receiver.
In the Networked-Internet with IPSec VPN mode, Extio 3 receivers operate on a secure connection
over a virtual private network. The Active Directory authentication will be available in this mode.
Note:
background color in the Windows host configuration.
Do the following to operate your Extio 3 units over internet with IPSec VPN:
Install your card –
1
 Set
Power recovery policy
This will allow the remote units to power up and return to a usable state.
 The
Routing scheme
Note: This only needs to be done if your setup does not support Multicast packets
(for example, GRE tunnels).
Target bit rate (quality)
Low
Typical
Low
Typical
Low
Typical
Low
Typical
The Networked-Internet with IPSec VPN mode is only available on the receiver. The
To ensure best performance of the VPN, we recommend that you use a solid
see "Installing your Extio 3 transmitter card", page
to (
Always start Transmitter
defaults to (
Unicast Transmitter
64.
Bandwidth per stream
(Mbps)
15
30
16.5
33.1
25
50
50
100
 
Settings More options
 
Settings Streaming
see "Using the OSD
*
28.
Matrox Extio 3 Series – User Guide 15
).
).