Table of Contents
Advertisement
Installation instructions
3.5 Installation
3.5.1 Preparing for the installation
Check that there is sufficient room for the machine at the installation location.
•
•
3.5.2 Positioning the machine
Check the following points before the machine is placed in position:
•
•
•
Place the machine in position and check that it, and any accessories, are
horizontally level. Adjust the height with the legs.
•
•
Once the machine has been filled with water, do another check to make sure the
machine is horizontal.
Assembling the divided machine (optional)
Parts which must be assembled are prepacked inside each section together with
the necessary bolts, nuts, etc.
WD-40BRE
Check that correct connections are available for water, electricity, drainage
and possibly steam at the installation location. See TECHNICAL
SPECIFICATIONS.
Check that the overheating protection device is reset.
Check that the fuse for the machine at the site is off, blocked and that
outgoing electrical circuits from the machine are non-live.
Remove the protective plastic on the sides which are to be stood against a
wall.
The distance between the wall and machine should be at least 50 mm.
Lateral tilt: Place a spirit level on the body of the machine at the infeed and
outfeed.
The machine's longitudinal direction: Place the spirit level across the body
of the machine.
13
Rev. (202303)
Advertisement
Table of Contents
