Table of Contents
Advertisement
Installation instructions
3.4 Unpacking
3.4.1 Marking of the machine
•
Check against the delivery note that all the units have been delivered.
•
Remove the packaging, but leave the pallet and any transport supports in
place.
•
Packaging must be sent for destruction or recycling in accordance with
local regulations.
•
Inspect the machine for any transport damage.
•
Lift the section at both ends using a handtruck. Screw down the legs (B) so
that they extend below the bottom of the pallet (C). Lower the section. Split
the pallet and remove it.
•
If the section should need to be lifted again from the short sides, a wooden
runner should be placed under the cross-bar (A) on the section stand.
A
A = Stand cross-bar
B = Leg
C = Pallet
D = Handtruck
The machine is marked on the outside of the packaging with the following
information:
•
Arrows which indicate the feed direction of the machine
•
Marking of the front with the text FRONT
FRONT
Marking of the packaging
WD-40BRE
B
C
12
Rev. (202303)
A
D
40BRE_02
40BRE_01
Advertisement
Table of Contents
