Reset Modes; Use Factory Firmware - Extron electronics TouchLink TLP Pro 320C User Manual

Reset Modes

The TLP Pro 320 C touchpanel has three reset modes:
•
•
•
To initiate these modes, press the
removing the bezel (see

Use Factory Firmware

Purpose and notes
Use this mode to temporarily boot up the unit with factory installed firmware for a single
power cycle in the event that a firmware update has failed or if incompatibility issues arise with
user-loaded firmware.
NOTE:
Activation
To start the Use Factory Firmware reset mode and replace firmware:
1.
2.
Result
The unit continues to run factory-installed firmware until the user updates the firmware or
power is cycled to the unit, which then reboots with the last loaded version of the firmware.
The touchpanel reverts to the factory default firmware. Event scripting does not start if the unit
is powered on in this mode. All user files and settings such as drivers, adjustments, and IP
settings are maintained.
NOTE:
Use Factory Firmware (see below).
Reset All IP Settings
(see page 36).
Reset to Factory Defaults
figure 11,
User-defined Web pages may not work correctly with an earlier firmware version.
On the panel, hold down the recessed
When power is restored, the Reset LED lights. Hold the
2 seconds before releasing it. The touchpanel enters factory firmware mode.
Upload new firmware to the unit as desired (see
NOTE: After a Use Factory Firmware reset is performed, update the TouchLink Pro
firmware to the latest version. Do not operate the touchpanel firmware version that
results from the reset. This mode temporarily resets the unit to factory default until
power is recycled. If you want to use the factory default firmware, you must upload
that version again (see
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
(see page 36).
button, which is found on the front panel after
Reset
F on page 15).
button while applying power to the unit.
Reset
Reset
Updating the Firmware
Updating the Firmware on page 32).
TLP Pro 320C • Reference Material
button for a further
on page 32).
36