Tools Required For Installation; Included Parts - Extron electronics TouchLink TLP Pro 320C User Manual

Tools Required for Installation

Figure 2.

Included Parts

Open the shipping container and verify that all the following components are present:
* The unit may be provided without a power module or with a different power module (see the
table below).
AC Power Module
Pass-through AAPs
Blank AAPs
1-position Bracket Kit
2-position Bracket Kit
3-position Bracket Kit
NOTES:
Figure 3.
Marking Pen
Tape Measure
Tools Required to Install the TLP Pro 320C
Table Clamps
AC Power Module*
Zip Ties
TLP Pro 320C
1
2,3
4
Inside the US, the TLP Pro 320C can be purchased with or without an AC power
1
module. Outside the US, see
suitable for your location.
Each AAP Bracket Kit consists of two brackets. The rear bracket is higher than the
2
front bracket and has two holes for screws.
Active or Passive AAPs are not provided and must be purchased separately (see
3
www.extron.com).
Single-space brackets can only be installed in one location (see the
4
figure on page 12).
Parts Included with the TLP Pro 320C
Safety Glasses
Vacuum Cleaner
Phillips Screw Driver
1/4" Hex Nut Driver
Blank AAPs
1 Pos 2 Pos
AAP Shelf Bracket Kits
(2 brackets/kit)
Extron #4−40 Screws
Removal Tool and Nuts
US Power Universal Power
Module Module
1 1
4 3
3 3
0 1
2 1
1 1
www.extron.com to find a power module that is
TLP Pro 320C • Mounting
Square
Pass-thru AAPs
3 Pos
Without Power
Module
0
4
5
0
3
1
note and
7