Reset Modes; Use Factory Firmware; Reset All Ip Settings - Extron electronics TouchLink Pro Series User Manual

Reset Modes

These touchpanels have four reset modes that are initiated by pressing the
•
•
•
•
The
or

Use Factory Firmware

This mode is used to boot up the unit with factory-installed firmware for a single power cycle
in the event of a firmware update that failed or incompatibility issues arising with user-loaded
firmware.
Activation
1.
2.
Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is powered
on in this mode. All user files and settings such as drivers, adjustments, and IP settings are
maintained.
NOTE:

Reset All IP Settings

This mode resets all IP settings to factory defaults.
Activation
To reset all IP settings:
1.
2.
Result
Reset All IP Settings mode:
•
•
•
•
•
•
•
Use Factory Firmware
Reset All IP Settings
Reset to Factory Defaults
Enable or Disable the DHCP Client
Reset button is found on the rear panel (see
figure 5, , on page 9, for TG models).
I
On the touchpanel, hold down the recessed
unit. When power is restored, the Reset LED lights. Hold the
seconds before releasing it. The touchpanel enters factory firmware mode.
Upload new firmware to the unit as desired (see
NOTE: Do not continue to operate the touchpanel using the factory firmware version. If
you want to use the factory default firmware, you must upload that version again (see
Updating the Firmware).
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
Hold down the Reset button until the Reset LED blinks twice (once at 3 seconds and again
at 6 seconds).
Reset momentarily (for <1 second) within 1 second. Nothing happens if
Release and press
the momentary press does not occur within 1 second.
Sets the IP address back to factory default (
Sets the subnet back to factory default (
Sets the default gateway address to the factory default (
DNS Primary address back to the factory default (
Sets the DHCP back to factory default (Off).
Sets the Hostname back to factory default (
Sets the Domain name back to factory default (Blank).
TLP Pro 1225, 1525, and 1725 Series • Reference Material
figure 4, C , on page 8, for MG models;
Reset button while applying power to the
Reset button for a further two
Updating the Firmware
192.168.254.251 ).
255.255.255.0 ).
0.0.0.0 ).
127.0.0.1 ).
TLP-Pro-1225MG-AB-CD-EF ).
Reset button:
on page 25).
34