Mounting The Tlp Pro 320C Enclosure - Extron electronics TouchLink TLP Pro 320C User Manual

Mounting the TLP Pro 320C Enclosure

Mount the cable cubby enclosure in the table.
CAUTION:
ATTENTION : Les extrémités à brides du haut de la surface du boîtier sont aiguisées.
1.
2.
3.
4.
5.
The flanged edges of the top of the surface enclosure are sharp. These
edges are also soft and may be easily nicked or bent. Exercise caution when handling
the enclosure to prevent personal injury or damage to the enclosure.
Ces extrémités sont aussi lisses et peuvent facilement être coupées ou pliées. Soyez
prudents lorsque vous manipulez le boîtier afin d'éviter de l'endommager ou de vous
blesser.
Mounting the TLP Pro 320C Enclosure
Figure 9.
Remove the edge grommet protecting the edges of the trim ring (
on the finished surfaces.
ATTENTION:
• Do not use isopropyl alcohol or other solvents to clean the Cable Cubby.
Strong solvents will ruin some finishes.
• Ne pas utiliser de l'alcool isoproprylique ou d'autres solvants pour nettoyer le
Cable Cubby. Les solvants forts endommageront certaines finitions.
Carefully lower the enclosure into the hole cut in the table (see
page 8). Ensure the trim ring (
Under the table, attach the table clamps (
may be necessary to loosen the wingnuts (
Tighten the Phillips head screws until the clamp faces (
bottom of the table.
To prevent the screws from becoming loose, secure the wingnuts against the table clamp
bodies.
5 5
4 4
1 1
3 3
2 2
) is flush with the top of the table.
5
3 ) to the pins on each side of the enclosure. It
) and the Phillips head screws (
1
) are tightly secured against the
4
TLP Pro 320C • Mounting
) and the plastic film
5
Cutting the Surface on
).
2
14