Table of Contents
Advertisement
Mode
Light source on
Using the Remote user interface (UI)
Use the remote user interface (UI) to access projector functionality.
The Remote user interface (UI) is available as an accessory.
1. Log into the Remote UI.
The default IP address is 192.168.206.110.
2. From the Remote UI default page, to access the main projector user interface, select the
Projector Control tab.
3. To upload and download files from the projector, use the File Menu.
Examples of items that can be uploaded include:
•
Projector upgrade packages
•
Backup packages to restore from
•
Rental files to license the projector for Rental mode
•
Test patterns (PNG files only)
•
Gamma files
Examples of items that can be downloaded include:
•
Projector backup files
•
Projector certificates (required for content decryption)
•
Interrogator files (for support and troubleshooting)
4. If the projector has a GDC IMB SR-1000 installed and configured, access the GDC IMB Web UI
by using the Media Block tab.
Setting up the chiller unit
For detailed information on setting up the chiller, refer to the documentation provided by the
manufacturer of the chiller unit.
Once the chiller is connected to AC and the chiller communication cable is connected to the projector,
the projector controls the chiller automatically to maintain the required coolant temperature.
CP4445-RGB and CP4455-RGB Installation and Setup Guide
020-103746-01 Rev. 1 (11-2022)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
• CineLife+ electronics and light engine are on.
• LOS is on.
• Fans run at full speed.
• Chiller is on (CP4445-RGB and CP4455-RGB projectors only).
• IMB is on.
Installing and setting up
36
Advertisement
Table of Contents
