Figure 97. Installing the rear mounting front PERC module
Next steps
1. If removed,
install the drive
2. If installed,
remove the air shroud
3.
Install the drive backplane
4. Follow the procedure listed in
Removing the adapter PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
4. Disconnect all the cables from the adapter PERC (APERC) card, observe the cable routing.
NOTE:
APERC module must be installed only in expansion card riser 1 or riser 2.
Steps
1. TIlt the expansion card retention latch lock to open.
2. Pull the card holder before removing the card from the riser.
3. Hold the APERC module by the edges. and pull the module from the expansion card connector on the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
94
Installing and removing system components
backplane.
or
remove the GPU air
cover.
After working inside your
Safety
instructions.
Before working inside your
riser.
shroud.
system.
system.