Bay Networks 5393 Hardware Installation Manual page 86

Chapter 3 ROM Monitor Commands
3-10 Remote Annex 5393/PRI Hardware Installation Guide
The boot –l command downloads and saves the operational image to
non-volatile memory, erases the existing Flash memory, copies the
new image from non-volatile memory to Flash memory, and then
executes the image.
After executing a boot –l, the ls command may not show the
newly-loaded image.
The boot –l command display looks similar to this:
monitor:: boot –l
Enter boot file name [(ip) "oper.63.enet", \
(mop) "OPER_63_ENET.SYS"]::
Requesting default boot file "OPER_63_ENET.SYS" for \
MOP/VMS loads and "oper.63.enet" for all other protocols.\
Unanswered requests shown as '?',transmission errors as'*'.
Requesting boot from 192.9.200.88 via Ethernet...
Booting BFS file using open delay of 8
Booting from 192.9.200.88
Header received OK.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .EOF
Saving image into storage device ...
Erasing device
|----------------------------|
..............................
Erase completed
Storing image .............
Storage completed
Beginning execution of image...
Annex Command Line Interpreter * Copyright 1991, 1995\
Xylogics, Inc.
Received data blocks shown as '.'.