Bay Networks 5393 Hardware Installation Manual page 69

Chapter 2 Installing the Remote Annex 5393/PRI
The default image file name is:
oper.63.enet
The following example shows how the image command is used
to set up a Remote Annex boot from the /tftpboot/annex/ directory.
When you enter the load directory name, make sure you end the
pathname with a backslash character.
Image name: <invalid or uninitialized> Default:
"oper.63.enet"
Enter Image name::oper.63.enet
Image name: "oper.63.enet"
TFTP load directory:
Enter TFTP load directory::/tftpboot/annex
TFTP Dump path/filename: <uninitialized> Default :
"dump.134.117.6.34"
Enter TFTP Dump path/filename::/tftpboot/annex/
dump.134.117.6.34
Using current TFTP Dump path/filename.
monitor::
2 Enter the boot command.
The boot command display looks like this:
Enter boot file name[oper.63.enet]::
Requesting boot file "oper.63.enet".
Unanswered requests shown as '?',transmission errors
as '*'.
Requesting boot from 192.9.200.88 via Ethernet...
Booting BFS file using open delay of 8?
Booting TFTP file using open delay of 8
Booting TFTP file from 192.9.200.88
Header received OK. Received data blocks shown as '.'.
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . EOF
Remote Annex 5393/PRI Hardware Installation Guide 2-27