Chapter 2
Installing the Remote Annex 5393/PRI
2-2
Remote Annex 5393/PRI Hardware Installation Guide
An appropriate subnet mask
A host with Remote Annex software installed
The Remote Annex 5393/PRI can receive its operational image from
any one of these sources:
A UNIX host
FLASH memory (self boot)
Another Remote Annex 5393/PRI configured as a boot host
A Windows NT host
The Remote Annex 5393/PRI supports Windows NT
tools. Remote Annex Server Tools for Windows NT
you to boot and configure the Remote Annex 5393/PRI on a
Windows NT
Remote Annex Server Tools for Windows NT® User Guide.
Table 2-1
outlines the different configurations the Remote Annex
5393/PRI supports.
Table 2-1. Remote Annex 5393/PRI Configuration Options
Device on which the Operational
Software and Image is installed
UNIX Load Host
Another Remote Annex
5393/PRI configured as a
load server
Self-boot (from the image
contained in Flash memory)
®
Windows NT
host
®
network. For more information, refer to the
Remote Annex
Must Be
Connected to the
Network
Yes
Yes
No
Yes
®
host
®
allows
Input Device used to
Enter Basic Configuration
Parameter Values
Service Port Terminal
Service Port Terminal
Service Port Terminal
Service Port Terminal