Net - Bay Networks 5393 Hardware Installation Manual

Chapter 3 ROM Monitor Commands
3-18 Remote Annex 5393/PRI Hardware Installation Guide

net

The net command executes an Ethernet transceiver loopback test on
the local area network. The command syntax is:
net
When you enter the net command, the following prompt is displayed:
Enter Segment to be used [1]:
This transceiver loopback test sends out a short test packet from the
Remote Annex through the transceiver to test the integrity of the
network.
The Ethernet transceiver loopback test causes the Net LED to turn off.
If the unit passes this test, the service port terminal displays PASSED.
If the Remote Annex fails, the service port terminal displays an error
message. Failing this test indicates that either the Remote Annex, its
transceiver cable, its transceiver, or the Ethernet is bad.