Installing To And Loading From A Unix Host - Bay Networks 5393 Hardware Installation Manual

This section describes:
How to install the Remote Annex's operational software and
image on a device that resides on a network accessible to the
Remote Annex.
How to download the operational image from the device to
the Remote Annex.

Installing to and Loading from a UNIX Host

This section contains a description of what you need to do to install
the Remote Annex's operational software and image to a UNIX host.
See the Remote Annex Administrator's Guide for UNIX for additional
information.
1 Install the image on a UNIX host. The software installation notes
describe how to do this.
If you have a BOOTP server, boot the Remote
Annex. Otherwise, continue to the next step.
2 Execute the ROM Monitor addr command:
Enter the Remote Annex's Internet address.
Modify any other parameters that the Remote Annex
may require for the initial boot, i.e., the preferred load
host's Internet address and the subnet mask (see addr on
page 3-4).
3 Execute the boot command.
After successful execution of the boot command, the Remote
Annex is up and running (see boot on page 3-7).
Remote Annex 5393/PRI Hardware Installation Guide
Chapter 2 Installing the Remote Annex 5393/PRI
2-29