Connecting The Terminal; Table 2-3. Service Port Pin Assignments - Bay Networks 5393 Hardware Installation Manual

Table 2-3. Service Port Pin Assignments

Terminal
DB-9 DB-25
2 3
3 2
5 7
RS-232 signals on other pins, such as DTR, CTS, and CD, are
ignored.

Connecting the Terminal

To connect the terminal to the service port, follow these steps:
1 Connect the terminal (or a computer in terminal emulation mode) to
the chassis service port with the RS-232 cable.
2 Set the terminal protocol. Configure according to the guidelines
defined inConnecting a Service Port Terminal
3 Press then
Enter
The Slot Selection menu
time, lists the modules installed in the chassis by slot number,
and lists the available commands.
Remote Annex 5393/PRI Hardware Installation Guide
Chapter 2 Installing the Remote Annex 5393/PRI
Function To Service Port
DB-9 Pins
Receive data 2
Transmit data 3
Signal ground 5
-T to display the Slot Selection menu.
Control
(Figure 2-7) shows the system date and
Function
Transmit data
Receive data
Signal ground
on page 2-14.
2-15