Bay Networks 5393 Hardware Installation Manual page 62

Chapter 2 Installing the Remote Annex 5393/PRI
ROM Software Rev: 101x
Board ID: 63
CPU Type: 80486DX2
Memory size: 8 Meg
Flash size: 2 Meg
TDM Interface: PRI T1 USA
SLC SRAM Size: 128 K
Port # 1
Modem ID 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883
Mod Status OK
Port # 13
Modem ID 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883
Mod Status OK
Hub Slot Hub CMB HW Rev
9
2-20 Remote Annex 5393/PRI Hardware Installation Guide
7 Verify the Remote Annex hardware configuration by typing config
and pressing
Return
The screen display looks similar to this:
REVISION/CONFIGURATION INFORMATION
Board Type: 5393
Ethernet Address: xx-xx-xx-xx-xx-xx
EEPROM size: 65504
Flash ID: 8989
Revision: VERSION A MGR=1.125
Modem Country Code: 63
2 3 4 5
OK OK OK OK
14 15 16 17
OK OK OK OK
Hub EE Rev
0.0 0.0
8 To verify and record the unit's Ethernet address for future reference,
type and press
addr -d
The screen display looks similar to this:
monitor:: addr -d
Ethernet address (hex): 00-00-81-XX-XX-XX
Internet address: <uninitialized>
Subnet mask: 255.255.0.0
Broadcast address: 0.0.0.0
Preferred Load Host address: <any host>
Preferred Dump Host address: 0.0.0.0
Load/Dump Gateway address: 0.0.0.0
Type of IP packet encapsulation: <ethernet>
Load Broadcast: Y
at the monitor prompt.
6 7 8 9
OK OK OK OK
18 19 20 21
OK OK OK OK
Hub EE Seg Sel Hub Jmpr Seg Sel
1
at the monitor prompt:
Return
10 11 12
OK OK OK
22 23 24
OK OK OK
1