Bay Networks 5393 Hardware Installation Manual page 116

Chapter 4 Troubleshooting Procedures
4-14 Remote Annex 5393/PRI Hardware Installation Guide
The host displays erpc_return 0 if it successfully receives a request and
is sending out an affirmative response. If any Remote Annex-related
files are missing or cannot be installed, contact technical support.
A PC host running the UNIX operating system has the erpcd daemon
(provided with the distribution and installed in /etc) running in the
background on the PC. Put the Remote Annex into Monitor Mode,
and the erpcd on the load host into Test Mode:
1 For erpcd on the load server host, as Superuser, kill the erpcd
program and restart it using the –D option:
# /usr/annex/erpcd -D5
2 For the Remote Annex, at the monitor prompt, enter:
# boot -v
Another Remote Annex 5393/PRI
When troubleshooting a Remote Annex 5393/PRI configured as a
load server host:
1 Use the CLI telnet command to access the unit and verify that it is up
and running.
2 Communicate with the unit on the Ethernet using the Superuser CLI
ping command.
3 Verify the unit's configuration using na.
The Remote Annex Administrator's Guide for UNIX provides more
information on these commands.
A Remote Annex 5393/PRI that has been reconfigured as a load server
host, but not rebooted, cannot boot another Remote Annex 5393/PRI
on the network. Rebooting the Remote Annex 5393/PRI load server
host ensures that the parameters are set.