Chapter 2
Installing the Remote Annex 5393/PRI
2-18
Remote Annex 5393/PRI Hardware Installation Guide
Remote Annex Parameters
The Remote Annex requires that you set certain parameters from the
ROM monitor before booting the unit from a host. Once the Remote
Annex is booted, you can change these parameters using the na utility.
Any changes to these parameters will require the unit to be rebooted
to take effect.
Table 2-4
parameters.
Table 2-4. Server Parameters
Parameter
Internet address
Subnet mask
Preferred load host
address
Load/dump gateway
Internet address
Broadcast address
Type of IP encapsulation
Initializing the Remote Annex
This section describes how to set up the Remote Annex, make the
connection to the System 5000 Hub for the first time, and enter
Monitor Mode to configure the module.
provides a brief description of these
Description
A unique 32-bit universal identifier that is
specified in dotted-decimal notation.
Defines which portion of the Internet
address is the network (all ones), the subnet
(all ones), and the host (all zeros) address.
The Internet address of the host from which
you want to boot.
The Internet address of the gateway, for
which you will be prompted, if the preferred
load host is on a different network.
An Internet address with a host id of all ones
or all zeros (for 4.2 BSD) to which all hosts
on a particular network will respond.
Specifies the method for accessing the
physical and network layer of the
transmission media. The default is: ethernet.