Config - Bay Networks 5393 Hardware Installation Manual

Chapter 3 ROM Monitor Commands
ROM Software Rev: 101x
Board ID: 63
CPU Type: 80486DX2
Memory size: 8 Meg
Flash size: 2 Meg
TDM Interface: PRI T1 USA
SLC SRAM Size: 128 K
Port #
Modem ID
Mod Status
Port #
Modem ID
Mod Status
Hub Slot Hub CMB HW Rev
9
3-12 Remote Annex 5393/PRI Hardware Installation Guide
config
The config command displays the current configuration information
and revision levels for the Remote Annex. The config command
displays revision information, the amount of memory installed, T1 or
E1 configuration information, and a description of the number and
type of modems installed. The command syntax is:
config
The config command display for a Remote Annex with 24 modems
(T1) looks similar to this:
REVISION/CONFIGURATION INFORMATION
Board Type: 5393
Ethernet Address: xx-xx-xx-xx-xx-xx
EEPROM size: 65504
Flash ID: 8989
Revision: VERSION A MGR=1.125
Modem Country Code: 63
1 2 3 4
2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883
OK OK OK OK
13 14 15 16
2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883 2883
OK OK OK OK
Hub EE Rev
0.0
This display is typical for T1 versions. For E1 versions,
information on 32 ports will be shown. For modem-less
versions, no port or modem information will be shown.
5 6 7 8
OK OK OK OK
17 18 19 20
OK OK OK OK
Hub EE Seg Sel
0.0 1
9 10 11 12
OK OK OK OK
21 22 23 24
OK OK OK OK
Hub Jmpr Seg Sel
1