Chapter 2 Installing The Remote Annex 5393/Pri; Before You Begin - Bay Networks 5393 Hardware Installation Manual

Before you Begin

Chapter 2
T
his chapter describes how to install your Remote Annex 5393/PRI
hardware and software, and connect it to a System 5000 Hub. This
chapter provides the following information:
Before you Begin
Installing the Remote Annex 5393/PRI
Testing the Installation
Connecting a PRI ISDN Network Interface
Connecting a Service Port Terminal
Initial Setup and Using the ROM Monitor
Auto-initializing the ROMs
Installing the Software and Loading the Operational Image
Self-booting the Remote Annex 5393/PRI
Invoking the Console Monitor
To successfully install the Remote Annex, you need:
A 3/16-inch flat-tip screwdriver
An antistatic mat and wrist strap (attached to an antistatic
leash)
A service port terminal and cable
A valid IP address
Remote Annex 5393/PRI Hardware Installation Guide
Installing the Remote Annex
5393/PRI
2-1