Bay Networks 5393 Hardware Installation Manual page 73

7 Press r to reset the module.
The following message is displayed:
Are you sure you want to RESET this module? (Y/N):
8 Press y; then press
The Slot Selection menu is displayed.
9 Within 10 seconds, press c to connect to the Remote Annex.
The following prompt is displayed:
Enter slot # (1-14):
If you do not make the connection in time, reset the server by
pressing -T to return to the Slot Selection menu and
Control
following the prompts.
10 Enter the slot number for the Remote Annex you are booting.
11 Wait for the following prompt:
To enter "Monitor Mode" please depress the SPACE key
within the next 10 seconds.
12 Press the space bar within 10 seconds.
If you do not press the space bar within the allotted time, press
-T and reset the server again.
Control
After a few seconds, the following text is displayed:
Monitor Mode selected, please wait for Confidence tests
to complete.
System Reset - Entering Monitor Mode
Then the monitor prompt is displayed:
monitor::
13 Enter the addr command at the monitor prompt.
The following prompt is displayed:
Enter module IP address::
Remote Annex 5393/PRI Hardware Installation Guide
Chapter 2 Installing the Remote Annex 5393/PRI
twice.
Escape
2-31