Erase - Bay Networks 5393 Hardware Installation Manual

erase

The erase command erases the contents of non-volatile memory
(either EEPROM or Flash memory). Erasing EEPROM restores all
parameters to factory default values. Erasing Flash memory erases
the self boot image.
Caution should be used concerning the Flash memory. If
you don't have an alternate source for the boot image, and
you erase the image in Flash memory with the erase
command, you will not be able to boot your Remote Annex.
The syntax is:
erase
The erase command prompts for the non-volatile memory to erase:
EEPROM or FLASH. Entering 1 at the prompt causes the Remote
Annex to erase the EEPROM (configuration information); entering 2
at the prompt causes the Remote Annex to erase the FLASH memory
(self-boot image).
The erase command does not erase the Ethernet address.
Since the erase command erases the IP address, you must use
the addr command to re-enter the Remote Annex's IP address
before reloading any software.
Remote Annex 5393/PRI Hardware Installation Guide
Chapter 3 ROM Monitor Commands
3-13