Command Descriptions - Bay Networks 5393 Hardware Installation Manual

Chapter 3 ROM Monitor Commands

Command Descriptions

3-2 Remote Annex 5393/PRI Hardware Installation Guide
Default or current values for parameters are displayed in brackets.
For example:
Enter broadcast address [132.245.6.255]:
At the prompt, enter a different value, or press
displayed value unchanged.
You can use unique abbreviations for all ROM Monitor commands
except erase. For example, enter boot as bo, and enter net as n. If you
enter an abbreviation that is not unique, an error message describing
the command as ambiguous is displayed on the service port terminal.
Table 3-1 lists the ROM Monitor commands; the following subsections
describe them.
Table 3-1. ROM Monitor Commands
Command Description
addr [-d] Displays and sets
EEPROM values
relevant to IP network
addressing, including
the unit's IP address.
boot [-v] [<file>] Manually boots and
loads the unit's
operating code.
boot [-l] [<file>] Erases the existing
Flash memory and
copies a new image to
Flash memory.
(continued on next page)
to leave the
Return
Use
Changing IP
configuration parameters.
Changing the address of
the boot image.
Upgrading or replacing
the Flash image.