Annex Command - Bay Networks 5390 Administering

Communications server

Hide thumbs Also See for 5390:

Table of Contents

annex Command

The annex command establishes a default annex_list that is used in subsequent commands. Before

issuing an na command, specify the Model 5390 server to which the executed command refers. The

Model 5390 servers you specify using the annex command become the default annex_list. You can

group several Model 5390 servers into a single list, and then issue one command for the entire group

of Model 5390 servers. The syntax is:

annex annex_list

The following example creates an annex_list containing one Model 5390 server with the Internet

address 132.245.6.40:

command: annex 132.245.6.40

The following example creates an annex_list containing two Model 5390 servers—one specified by

its IP address, and the other specified by its name:

command: annex 132.245.6.40,frontlobby

The following example shows how na prompts for missing arguments:

command: annex

enter default annex list: 132.245.6.40,frontlobby

The following annex command displays a message identifying the specified Model 5390 server, its

Internet address, the number of serial lines it has, and its software version:

command: annex 132.245.6.1

132.245.6.1: Remote Annex R10.1,24 ports

The following annex command causes the Model 5390 server to prompt for an administrative

password, provided that the password has been set and security has been enabled:

command: annex frontlobby

Password for 132.245.6.40 <frontlobby>

frontlobby: Remote Annex R10.1,24 ports

NOTE: If you use the na command password to deﬁne a default pass-

word for this na session, and that password matches the Model 5390

administrative password, no password prompt appears and normal pro-

cessing continues (see password Command on page C1-14).