Figure 25 Menu 11.3 - Remote Node Network Layer Options; Table 19 Menu 11.3 Remote Node Network Layer Options - Nortel 252 Configuration

2 In menu 11.1, make sure IP is among the protocols in the Route field.
3 Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select
Yes, then press [ENTER] to display Menu 11.3 – Remote Node Network
Layer Options.
Figure 25 Menu 11.3 – Remote Node Network Layer Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Table 19 explains fields in

Table 19 Menu 11.3 Remote Node Network Layer Options

Field Description
IP Address Press [SPACE BAR] and then [ENTER] to select
Assignment Dynamic if the remote node is using a dynamically
assigned IP address or Static if it is using a static (fixed)
IP address. You will only be able to configure this in the
ISP node (also the one you configure in menu 4),all other
nodes are set to Static.
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet Type the subnet mask assigned to the remote node.
Mask
Nortel Business Secure Router 252 Configuration — Advanced
Chapter 6 Remote Node setup 91
Bridge Options:
Ethernet Addr Timeout(min)=
Figure 25.
Example
Dynamic