Figure 37 Menu 11.3 - Applying Nat To The Remote Node; Table 23 Applying Nat In Menus 4 & 11.3 - Nortel 252 Configuration

Figure 37 Menu 11.3 – Applying NAT to the Remote Node
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 15
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
Press Space Bar to Toggle.
Table 23
Table 23 Applying NAT in Menus 4 & 11.3
Field
Network
Address
Translation
Enter here to CONFIRM or ESC to CANCEL:
describes the fields in
Description
When you select this option the SMT uses Address
Mapping Set 1 (menu 15.1 -
page 108 for further discussion). Choose Full Feature if
you have multiple public WAN IP addresses for your
Business Secure Router.
When you select Full Feature you must configure at least
one address mapping set!
NAT is disabled when you select this option.
When you select this option the SMT uses Address
Mapping Set 255 (menu 15.1 -
page 108). Choose SUA Only if you have just one public
WAN IP address for your Business Secure Router.
Nortel Business Secure Router 252 Configuration — Advanced
Chapter 9 Network Address Translation (NAT) 107
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Figure 37.
"Address Mapping Sets" on
"Address Mapping Sets" on
Options
Full Feature
None
SUA Only