Nortel 252 Configuration page 279

Table 67 IP commands
Command
status
udp
status
rip
accept
activate
merge
refuse
request
reverse
status
trace
mode
dialin_user
tcp status
telnet
tftp
support
stats
traceroute
xparent join
break
urlfilter
<gateway>
[on|off]
<gateway>
<addr> [port]
[on|off]
<iface> in [mode]
<iface> out
[mode]
[show|in|out|both
|none]
<host> [port]
<host> [ttl]
[wait] [queries]
<iface1>
[<iface2>]
<iface>
Nortel Business Secure Router 252 Configuration — Advanced
Appendix G Command Interpreter 279
Description
Displays IP statistic counters.
Displays the UDP status.
These are the Routing Information Protocol
commands.
Drops an entry from the RIP refuse list.
Enables RIP.
Sets the RIP merge flag.
Adds an entry to the RIP refuse list.
Sends a RIP request to the specified address
and port.
RIP Poisoned Reverse.
Displays RIP statistic counters.
Enables the RIP debug trace.
Sets the Business Secure Router to use the
RIP information it receives.
Sets the Business Secure Router to broadcast
its routing table.
Shows the dial-in user RIP direction.
Displays the TCP statistic counters.
Creates a Telnet connection to the specified
host.
Displays whether or not TFTP is supported.
Displays the TFTP statistics.
Sends ICMP packets to trace the route of a
remote host.
Add iface2 to the iface1's group.
Remove the specified interface from the
ipxparent group.