Figure 65 Menu 21.1.1.1 - Generic Filter Rule; Table 32 Generic Filter Rule Menu Fields - Nortel 252 Configuration

Figure 65 Menu 21.1.1.1 – Generic Filter Rule
Press Space Bar to Toggle.
Table 32

Table 32 Generic Filter Rule Menu fields

Field
Filter #
Filter
Type
Active
Offset
Length
Mask
Menu 21.1.1.1 - Generic Filter Rule
Filter #: 2,3
Filter Type= Generic Filter Rule
Active= No
Offset= 0
Length= 0
Mask= N/A
Value= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
describes the fields in the Generic Filter Rule menu.
Description
This is the filter set, filter rule coordinates, for example, 2,3
refers to the second filter set and the third rule of that set.
Use [SPACE BAR] and then [ENTER] to select a rule type.
Parameters displayed below each type will be different. TCP/
IP filter rules are used to filter IP packets while generic filter
rules allow filtering of non-IP packets.
Select Yes to turn on the filter rule or No to turn it off.
Enter the starting byte of the data portion in the packet that
you wish to compare. The range for this field is from 0 to
255.
Enter the byte count of the data portion in the packet that you
wish to compare. The range for this field is 0 to 8.
Enter the mask (in Hexadecimal notation) to apply to the
data portion before comparison.
Nortel Business Secure Router 252 Configuration — Advanced
Chapter 11 Filter configuration 145
Log= None
Options
Generic Filter
Rule
TCP/IP Filter
Rule
Yes / No
0-255
0-8