Figure 115 Applying Schedule Sets To A Remote Node (Pppoe) - Nortel 252 Configuration

216 Chapter 18 Call scheduling
After you configure your schedule sets, you must apply them to the desired
remote nodes. Enter 11 from the Main Menu and then enter the target remote
node index. Using [SPACE BAR], select PPPoE or PPPoA in the
Encapsulation field and then press [ENTER] to make the schedule sets field
available, as shown in

Figure 115 Applying Schedule Sets to a Remote Node (PPPoE)

Rem Node Name= ChangeMe
Active= Yes
Encapsulation= PPPoA
Multiplexing= LLC-based
Service Name= N/A
Incoming:
Outgoing:
You can apply up to four schedule sets, separated by commas, for one remote
node. Change the schedule set numbers to your preferences.
NN47923-501
Figure
Menu 11.1 - Remote Node Profile
Rem Login=
Rem Password= ********
My Login=
My Password= ********
Authen= CHAP/PAP
Press ENTER to Confirm or ESC to Cancel:
115.
Route= IP
Bridge= No
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= N/A
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedule Sets=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100