196 Chapter 15 Firmware and configuration file maintenance
Figure 104 Menu 24.7.2 as seen using the Console Port
Menu 24.7.2 - System Maintenance - Upload System Configuration File
2
3
NN47923-501
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
system.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"PlsChgMe!".
Do You Wish To Proceed:(Y/N)
After the "Starting Xmodem upload" message appears, activate the Xmodem
protocol on your computer. Follow the procedure in
firmware using HyperTerminal" on page
communications programs is similar.
Enter
to restart the Business Secure Router.
atgo
"Uploading Xmodem
195. The procedure for other serial