Nortel 252 Configuration page 273

Table 64 Sys commands
Command
level
type
disp
clear
call
encapmask
trcpacket
create
destroy
channel
string
switch
disp
udp
udp switch
udp addr
udp port
[level]
<bitmap>
[mask]
<entry> <size>
<name> [none|incoming|
outgoing|bothway]
[on|off]
[on|off]
[on|off]
<addr>
<port>
Nortel Business Secure Router 252 Configuration — Advanced
Appendix G Command Interpreter 273
Description
Sets the level (1-10) of trace logs (1
shows the least) to display.
Uses hexadecimal characters to set the
type of trace logs to record.
Shows the trace log.
Erases the trace log.
Shows call events.
Shows which type of encapsulation the
trace log records, or sets the
encapsulation if you specify the
encapsulation's hexadecimal
character.
Uses trace packets to capture parts of
packets in order to see the packet flow
from one interface to another.
Creates a packet trace buffer.
Removes the packet trace buffer.
Sets the packet trace direction for a
given channel.
Enables or disables the sending of a
log to the trace packet buffer when
configuration changes are made or
displays the current setting if neither
on/off is specified.
Enables or disables packet trace or
displays the current setting if neither on
nor off is specified.
Displays the trace packets.
Sends the trace packets to another
system using UDP.
Enables or disables the sending of the
trace packets to another system using
UDP or displays the current setting.
Sets the target IP address for sending
trace packets using UDP.
Sets the UDP port (should match that
of the target IP address) for sending
trace packets using UDP.