Nortel 252 Configuration page 287

Table 68 IPSec commands
Command
exUseMode
exUseMac
clientFailOver
keepAlive
ikeList
ikeDelete <rule index>
policyEdit <rule index>
policySave
ipsecList
policyList
policyDelete <rule index>
policyConfig
saIndex
active
lcAddrStart
protocol
controlPing
controlPingAddr
lcAddrType
lcAddrEndMask
lcPortStart
lcPortEnd
[enable|disable
]
[MAC address]
<IP address>
<IP address>
<IP address>
<Yes|No>
<rule index>
<Yes|No>
<IP>
<1:ICMP | 6:TCP
| 17:UDP>
<Yes|No>
<IP>
<0:single |
1:range |
2:subnet>
<IP>
<port>
<port>
Nortel Business Secure Router 252 Configuration — Advanced
Appendix G Command Interpreter 287
Description
Turns the exclusive use mode for the
Contivity Client tunnel on or off.
Specifies which MAC address is allowed
to use the Contivity Client tunnel with
exclusive use mode.
Sets the Contivity Client fail over IP
addresses (of back up remote Contivity
IPSec routers).
Turns the Keep Alive feature on or off.
Displays a summary of the IKE (phase 1)
rules.
Deletes the specified IPSec rule.
Edits the specified IP policy.
Saves the IP policy.
Displays a summary of the IPSec (phase
2) rules.
Displays the IP policies.
Deletes the specified IP policy.
Uses these commands to configure an IP
policy for an IPSec office tunnel rule.
Binds the IP policy to an IPSec rule.
Turns the IP policy on or off.
Sets the local starting IP address.
Sets the IP policy's protocol.
Turns control ping on or off.
Sets the control ping IP address.
Sets the local address type.
Sets the local ending IP address or
subnet mask.
Sets the local starting port number.
Sets the local ending port number.