Nortel 252 Configuration page 290

290 Appendix G Command Interpreter
Table 68 IPSec commands
Command
encr
DHG
aci
ipPool
natt
failover
NN47923-501
Description
Enables or disables the specified
<128AES_SHA1 |
encryption algorithm.
3DES_SHA1 |
3DES_MD5 |
DES_SHA1 |
DES_MD5 |
AH_SHA1 |
AH_MD5> <on |
off>
Enables or disables the specified
<DES_DH1 |
Diffie-Hellman encryption level.
3DES_DH2 |
128AES_DH5 >
<on | off>
Enables or disables the Use Static
static <on |
Address option.
off>
Select which IP pool, index is based on 1,
ipPool <index>
and inactive IP pool cannot be selected.
Before you configure an IP pool for client
load <index>
termination, you must load the specified
IP pool. Currently 3 IP pools are
supported, so the valid index is: 1~3
After changing the IP pool configuration,
save
use the save command to save the
modification to the ROM.
Enables or disables the loaded IP pool.
active
Sets the IP pool's name.
poolName
Sets the IP pool's starting IP address.
startAddr
Sets the IP pool's subnet.
subnet
Sets the number of IP addresses in the IP
size
pool.
Displays the current runtime IP pool
status
status of Client Termination.
Enables or disables NAT Traversal.
active <yes |
no>
Enables or disables Client IKE Source
portSwitch
Port Switching.
<enable |
disable>
Sets the NAT Traversal UDP port, valid
portNum
UDP port: 1025 ~ 65535.
Sets the client failover IP address.
<1 | 2 | 3> <IP>