Figure 33 Menu 12.1 - Edit Ip Static Route; Table 21 Ip Static Route Menu Fields - Nortel 252 Configuration

Figure 33 Menu 12.1 – Edit IP Static Route
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to CONFIRM or ESC to CANCEL:
Table 21

Table 21 IP Static Route Menu Fields

Field
Route #
Route Name
Active
Destination IP
Address
IP Subnet Mask Enter the IP subnet mask for this destination.
Gateway IP
Address
Metric
Private
describes the fields in
Description
This is the index number of the static route that you chose in menu 12.
Enter a descriptive name for this route. This is for identification
purposes only.
This field allows you to activate or deactivate this static route.
This parameter specifies the IP network address of the final
destination. Routing is always based on network number. If you need to
specify a route to a single host, use a subnet mask of 255.255.255.255
in the subnet mask field to force the network number to be identical to
the host ID.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your Business Secure Router that forwards the packet to
the destination. On the LAN, the gateway must be a router on the same
segment as your Business Secure Router; over the WAN, the gateway
must be the IP address of one of the remote nodes.
Enter a number from 1 to 15 to set the priority for the route among the
Business Secure Router routes. The smaller the number, the higher
priority the route has.
This parameter determines if the Business Secure Router includes the
route to this remote node in its RIP broadcasts. If set to Yes, this route
is kept private and not included in RIP broadcast. If No, the route to this
remote node is propagated to other hosts through RIP broadcasts.
After you complete filling in this menu, press [ENTER] at the message
"Press ENTER to Confirm..." to save your configuration, or press [ESC]
to cancel.
Nortel Business Secure Router 252 Configuration — Advanced
Chapter 7 IP Static Route Setup 101
Figure 33.